DT Etherlink IV
User Manual
- 106 -
8.1.5 Alarm at Local Craft Terminal (RS-232) Interface
Specification
Load Driver
Maximum Switching Voltage
60VDC
Maximum Current
150mA
Connector Type
DB9 female connector
8.1.6 Monitor or Local Craft Terminal (USB) Interface
Specification
USB V2.0 full and low speed
Data Rate
12Mbit/s
Protocol
Master/Slave,
Uses the USB communication device
class (CDC) drivers to take advantage of the installed
PC RS-232 software to talk over the USB
Connector Type
USB Type B female connector
8.1.7 Ethernet
Standard:
IEEE-802.3, VLAN IEEE-802.1Q, QoS IEEE-802.1P
Data Rate
10/100BaseT, Full/Half Duplex
Protocols
Data, Telnet, SNMP, WEB
Signal Level
Ethernet
MDI / MDI-X auto crossover
Supported
Auto Negotiation
Supported
Connector Type
RJ45, 8 pin
8.2
Power Supply
Specification
ETSI ETS 300 132-2
Voltage
38-72VDC local power or 38-230VDC remote power
Voltage for -24V models
18-36VDC local power or 72-230VDC remote power
Power Consumption @ 48VDC
(All DSL links up, Ethernet on,
Remote Power off)
Typ. 2.8W, SA-DT-ETH_IV
-2E1-DSL-2ETH
,V80
Typ. 3.6W, SA-DT-ETH_IV-
2E1-2DSL-2ETH
,V81
Typ. 2.3W, SA-DT-ETH_IV-
1DSL-2ETH
,V82
Typ. 3.1W, SA-DT-ETH_IV-
2DSL-2ETH
,V83
Typ. 4.5W, SA-DR-ETH_IV-4
DSL-
4Eth, V84
Typ. 7.1W, SA-DT-ETH_IV-1F-
2DSL
-3Eth,V84S
Typ. 2.8W, SA-DT-ETH_IV-
2N64-1DSL-2E1
,V85
Typ. 3.6W, SA-DT-ETH_IV-
2N64-2DSL-2E1
,V86
8.3
Environment
8.3.1 Climatic Conditions
Storage:
ETS 300 019-1-1 Class 1.2
(-25
C … +55
C)
Transportation:
ETS 300 019-1-2 Class 2.3
(-40
C … +70
C)
Operation:
ETS 300 019-1-3 Class 3.2
(-5
C … +45
C)
Higher Operation Temperature range available on request (-
20°C … +80°C)
8.3.2 EMC and Safety Standards
EN 300386 V1.4.1:2008
EN 50121-4:2006
EN 60950-1:2006
EN 55022:2006, Class B
EN 55024/A2:2003
EN 61000-4-2/A2:2001
