RVE Merak E750, Assembly Instructions Manual

Page: 32 / 56

RVE MERAK E750 - ASSEMBLY INSTRUCTIONS
TAIL PITCH LEVER ASSEMBLY AND INSTALLATION (5-6)
The tail pitch lever carbon plate is fixed to the aluminium tail pitch lever with two M2.5 x 6 mm
screws as shown in the pictures.
The control ball is secured to the carbon plate with a phillips head screw with a nylon lock-nut.
Threaded guiding pins are installed in the aluminium tail pitch lever with soft threadlocker.
Glue the two flanged bearings in the aluminium tail pitch lever with medium threadlocker.
Install the tail pitch lever assembly in the tail pitch lever support with the provided aluminium
bushings, then secure it with the
​ M3 x 8 mm button head screws using soft threadlocker.
Slide the tail slider assembly into the tail shaft first, then slide the tail pitch lever pins into
plastic bearing ring groove.
***Recommended tightening torque:
0.6 Nm for the M3 x 8 mm button
head screws
0.8 Nm for the M2.5 x 6 mm screws
and threaded guiding pins
32