RVE Merak E750, Assembly Instructions Manual

Page: 7 / 56

RVE MERAK E750 - ASSEMBLY INSTRUCTIONS
MOTOR BLOCK (1-2)
The motor block is designed with an integrated third bearing and a special helical pinion. Only
motors using 6mm shaft are compatible. Several pinions, 10t, 11t and 12t are available. Follow
the recommendations from Pinion Selection chapter in order to choose the correct pinion.
Insert first the selected pinion into the motor block bearing and lock the pinion nut using
medium threadlocker.
Optionally, bearing inner race can be fixed to the helical gear with medium threadlocker.
Install the engine into the motor block, fixing it with the two M4 x 10 mm button head screws,
using soft threadlocker. Align the motor shaft flat surface with one of the pinion threaded holes
and use the two M4 x 4 mm set screws to secure it. If the motor doesn’t have a flat surface, it
can be done with its center at approx. 10mm from motor mounting surface.
***Recommended tightening torque:
2 Nm for the M4 x 10 mm button head screws
1.2 Nm for the M4 x 4 mm set screws
7