RVE Merak E750, Assembly Instructions Manual, Page: 30 / 56

RVE MERAK E750 - ASSEMBLY INSTRUCTIONS
TAIL CASE ASSEMBLY (5-2, 5-3, 5-4)
Mount the left side plate to the tail case main block.
The left side plate is the wider one. Mount also the red
cylindrical spacer. Use for both operations M3 x 6 mm
button head screws with soft threadlocker.
Insert the tail boom brace clamp first (then the support
sponge if a fuselage is to be installed), then the tail
case clamp and finally the previously assembled tail
case.
Place the tail shaft in the case and mount the right side
plate with the tail pitch lever support using M3 x 8 mm
button head screws.
Check the tail shaft side play, adding shim washers if
needed.
Remember to insert the o-ring on the tail shaft.
Fix the tail case to the carbon tail tube. First insert the
M3 x 3 mm set screw till touching the carbon tube, then
screw half additional turn. Then tighten the tail case
clamp M3 x 8 mm screw using soft threadlocker.
Tightening torque is not provided for the M3 x 8 mm
screw, tighten it till the assembly is correctly secured.
***Recommended tightening torque:
1 Nm for the M3 x 6 mm and M3 x 8 mm button head screws
30