RVE Merak E750, Assembly Instructions Manual, Page: 37 / 56

RVE MERAK E750 - ASSEMBLY INSTRUCTIONS
First install the M3 threaded balls in the
servo horns using medium threadlocker.
Each servo is to be equipped with a inner
bushing servo horn, fixing it with the servo
horn screws provided with the servos.
Inner bushings are only available for ​ Futaba
25t standard spline servos
​
.
Each servo horn is clamped to its inner
bushing by means of a M2.5 x 6 mm screw
with medium threadlocker, but not right
now.
In order to guarantee a perfect servo setup,
servos and swash control levers need to be
centered.
Center the servos connecting them to a
receiver or servo tester. If you do it through
a Flybarless controller, remember to disable
gyros first.
Additionally, insert the provided pins to set
the elevator and aileron levers in neutral
position.
Adjust the connecting rods length and
install them. Finally fix each servo horn with
the M2.5 x 6 mm screws.
***Recommended tightening torque:
0.8 Nm for the M2.5 x 6 mm set screw
37