RUMBLE HOG RH7500, Operation Manual

Page: 98 / 164

98
Section 3 - operation
Joystick, Joystick Trigger (A), TRUCK SPEED Dial (B)
& E-Stop Button (C)
A
B
C
3.17 routine Shutdown
The routine shutdown procedure should be fol-
lowed each time the cutting system is deactivated
and the truck is shifted from WORK mode to
TRAVEL mode.
The shutdown procedure to shift the truck from
WORK mode to TRAVEL mode and deactivate the
cutting systems in this section provides general
instructions that will apply to most trucks with an
automatic transmission. However your truck may
be slightly different, depending on the chassis and
optional equipment selected. Always refer to the
placard on the back of the visor in the cab for
specific startup and shutdown instructions
for your truck.
NOTICE:
THE CONTROLLER DISPLAY SCREENS SHOWN IN THIS
SECTION ARE FOR DEMONSTRATION PURPOSES ONLY. THE
DISPLAY AND CONTROLS IN THE CONTROLLER ON YOUR
TRUCK MAY BE DIFFERENT. REFER TO THE SUNSOURCE
HOG TECHNOLOGIES USER GUIDE FOR A DESCRIPTION OF
THE CONTROLS AND FEATURES.
Routine Cutter Shutdown procedure:
1. Raise the cutter off the pavement.
2. Turn the TRUCK SPEED dial to 0 or bump the
joystick to stop the truck. Set the park brake.
3. Disengage the cruise control and allow engine
speed to drop to idle.
4. Press controller button (5) to stop the water pump.
Controller MAIN Screen & Control Buttons
Indicating Work Mode
Controller MAIN Screen & Control Buttons
Indicating Travel Mode
5. Press controller button (8) to stop cutter drum
rotation and controller button (6) to stop the ec-
centric.
6. Put the transmission in “N N” (NEUTRAL).
7.
Turn the MODE and OMSI PTO switches off.
Listen for the PTO to disengage and the red
TRAVEL icon in the controller to illuminate.
The transmission display will change from 4 4
to “N N.”