RUMBLE HOG RH7500, Operation Manual

Page: 85 / 164

85
Section 3 - operation
3.10 aligning the truck &
positioning the head
The truck must be properly positioned prior to set-
ting the head on the ground. The head must also
be in proper alignment prior to setting it on the
ground. Once the head is on the ground it cannot
be moved side to side unless the truck is moving.
Never attempt to move the head sideways while
the truck is sitting still.
Aligning the Truck
1. Position the truck over the line Activate Hydro-
static Drive (Set engine to 1000 RPM).
2. Make sure the video guidance monitors are
attached to the windshield.
3. Turn ON the camera switch.
4. Drive the truck in reverse.
5. Position the rear camera, so that it is in the
right relationship with the cutter teeth in ac-
cordance with the desired offset from the line.
6. Position the cutter head assembly at the center
of the truck or at the desired offset left or right.
Front Camera
Rear Camera
7. Drive the truck hydrostatically forward until
the line is passing through the center of the
camera for at least the length of the truck.