RUMBLE HOG RH7500, Operation Manual

Page: 78 / 164

78
Section 3 - operation
3.5 mounting monitors & cameras
The video system includes 2 monitors and 4
cameras that provide a complete video guidance
and monitoring system during cutting operations.
Each monitor is removable and secured to the
windshield with special vacuum cups during cut-
ting operations. The monitors obstruct the drivers
forward visibility, so they must be removed and
properly stored when the truck is in TRAVEL mode.
Monitors
Each monitor vacuum cup is equipped with a
manual pump that creates a strong suction to the
windshield. Use the following procedure to attach
the monitors.
1. Make sure the vacuum cups and windshield
are clean.
2. Hold the monitor against the windshield and
pump the plunger on the suction pump until
the red line on the plunger remains hidden in
the pump body, indicating the cup and monitor
are secure and ready for use.
CAUTION
IF THE RED LINE IS EXPOSED, IT INDICATES VACUUM
SUCTION IS WEAK AND THE MONITOR COULD RELEASE
FROM THE WINDSHIELD.
3. Check the plunger frequently to make sure the
cup remains securely attached. If the red line
begins to show, pump the plunger to increase
the vacuum.
Typical Monitor Mounted to Windshield Front Camera Mounted
4. Remove the monitor and clean the suction cup
and window if the red line becomes exposed
frequently.
WARNING
THE VIDEO MONITORS OBSTRUCT THE DRIVERS FORWARD
VISIBILITY AND COULD RELEASE FROM THE WINDSHIELD
UNEXPECTEDLY WHILE TRAVELING DOWN THE HIGHWAY
I N T R AV E L M O D E. R E S T R I C T E D V I S I B I L I T Y O R T H E
UNEXPECTED RELEASE OF A MONITOR COULD RESULT IN
AN ACCIDENT. ALWAYS REMOVE AND PROPERLY STORE
BOTH MONITORS BEFORE SHIFTING THE TRUCK TO TRAVEL
MODE AND DRIVING ON THE HIGHWAY.
Front Camera
The camera on the right side of the front fender
provides a full screen image of the shoulder in front
of the truck on the monitor dedicated to the forward
camera. An adjustable cross hair on the screen is
used for truck guidance and alignment purposes.
If the camera is not mounted, use the following
procedure to attach the camera.
1. Attach the camera to the bracket on the front
camera bar using the four bolts and locknuts.
Tighten locknuts securely.
2. Loosen the friction knob on the camera mount
and slide the camera to the desired position
on the bar.
3. Set the camera angle and tighten the friction
knob.
4. Attach the cat 5 cable to the camera.