RDC6445GT5 Laser cutting system hardware user manualV1.1
深圳市睿达科技有限公司
41
system uses a single positioning point logic. Press the “Position” key on the keyboard to set the
positioning point, and only the setting positioning point takes effect. When “Yes” is selected,
system uses a multi-positioning point logic, and the “Position” key on the keyboard is invalid.
The value of each positioning point needs to be set in the menu, see the following.
Start positioning point: 0~4 optional, display the positioning point to be used for the
next figure to be worked. No.0 positioning point represents the positioning point set by the
“Position” key on the panel in the single positioning point logic. 1~4 indicates the positioning
point number in the multi-positioning point logic. The next positioning point can be modified
to any point from 1 to 4, so as to control the starting point position during the next work
(provided that the positioning point is enabled). It cannot be modified to No.0 positioning
point (if it is a single positioning point logic, the No.0 positioning point is always taken).
Positioning point 1~4 enable: when the multi-positioning point logic is enabled, the
four positioning point can be disabled and enabled individually.
Once the multi-positioning point logic is selected, assuming that the initial
positioning point number is 1, and all four positioning points are enabled,
when the memory file is started (including the keyboard startup and PC
startup), or when the PC uses the direct output to start the work and the
option of “Take original positioning point as positioning point” is selected, a
different positioning point will be used each time the work is started. The
rotation sequence of positioning points is 1->2->3->4->1->2...... If the PC
adopts the direct output to start the work, and the “Take the current point as
positioning point” is selected, the system will always use the current point as
the positioning point.
Backup Factory Parameters
When pressing the “Backup Parameters”, the following interface will pop up:
Prompt
