LaserCuttistV1.2 Laser Cutting system
RuiDa Technology E-Mail:
1TH FLOOR,5TH BUILDING,NANYOU
TIANAN INDUSTRIAL ZONE,SHENZHEN
Web:
www.rd-acs.com
Phone: (086)0755-26066687
FAX: 0755-2698287
67
correctly, click “apply”, the bridges will be added on the curve automatically.
Add bridges with the number of the bridges.
If you select adding bridges with the bridges number, the number of bridges to be added should be
set. Then click “apply”, the bridges will be added automatically.
Manually add bridges
We can add the bridges manually. Select the “manual’ option and set the with of the bridge, you
can add the bridge anywhere on the curve.
Shown as picture 3-22.
Picture3-22 Adding bridge
2Introducing pin-in-out line
During laser cutting, the penetrate hole are usually located on the throwing away part of the metal
material. So the introducing pin-in-out line is always located on the throwing away part of the metal material.
The introducing pin-in-out line are the lines that connect the penetrate hole and start point of the curve
outline.
2 type of introducing line
：
Line
The length and the
intersection angle can be set. The result of the introducing line is shown as
picture 3-23.
