LaserCuttistV1.2 Laser Cutting system
RuiDa Technology E-Mail:
1TH FLOOR,5TH BUILDING,NANYOU
TIANAN INDUSTRIAL ZONE,SHENZHEN
Web:
www.rd-acs.com
Phone: (086)0755-26066687
FAX: 0755-2698287
34
Picture 2-19 Delay parameter
a)
Penetrate delay
：
When the laser head jumped to the point, a hole should be
penetrate
with laser. In order to penetrate a hole with laser on the metal material, the laser must
be on for a while with the laser head no moving. The laser on time is the penetrate
delay. The unit is ms.
b)
Tracing Delay
：
Laser tracing head moves down to the metal plane and to be the tracing
status. The moving down time is the trace delay. The delay must be sure that the laser
head can move close to the metal plane.
c)
Open blowing delay: the time that from Switching on the air valve and the air blowing
reaching a
stabilize pressure
d)
Close blowing delay: the time before close blowing.
e)
Rising delay
：
Moving the laser head to a position. The delay determines the rising height.
f)
Special punch:When select special punch, laser kept opening and closing play wear plate.
g)
Period: Laser opening and closing cycle.
h)
Pulse width:
The ration of laser light time by the cycle.
i)
Punch time:The time of special punch.
j)
Punch gas:The gas will be used to special punch.
k)
Gas pressure:The pressure of the punch gas.
4 File parameter
：
When import a file, some parameters should be set. As shown in picture 2-20.
