LaserCuttistV1.2 Laser Cutting system
RuiDa Technology E-Mail:
1TH FLOOR,5TH BUILDING,NANYOU
TIANAN INDUSTRIAL ZONE,SHENZHEN
Web:
www.rd-acs.com
Phone: (086)0755-26066687
FAX: 0755-2698287
75
Picture 3-35 Parallel line
For example, a polygon line is drew in the window. If you execute the parallel line function, two lines
will be added to the original polygon line. As is shown in picture 3-26. The black line in the picture is
the original line and the red lines are the parallel lines added.
If you do not select “delete original line”, then there 3 parallel lines. Now if you start a cutting, 3
lines will be cut. If you select “delete original line”, the original line will be deleted. There are two
lines totally.
Picture3-36 Parallel lines
7 Re-locate
When user want to cut some curves on the metal material that has some special mark point, you must
locate the metal material again according to the mark point. Only this is done, the curves can have a
certain relation with the mark point.
When you execute a re-location, please follow the hint displayed in the information area of
lasercuttist.
3.3 Information display
The information of cutting is displayed on the right control panel and the status area on the bottom. Just
shown in picture 3-38.
Picture 3-38 information hint area
The position of the cursor, machine status, coordinate mode, attribute of curve can be displayed. The count of the
data file has been cut is displayed in the area too.
Control panel is on the right of the window. The position of machine coordinate and the position of the work
