Rotwild R.C750 2020, Owner'S Manual, Page: 57 / 71

58
Rear wheel
Tools are needed to remove the rear wheel, in this
case an Allen key (size 5). Before you fit the axle,
make sure that the thread is clean and
undamaged. You must also check that the left
side of the dropout, which the head of the through
axle fits into, is free of dirt.
Push the lightly greased axle through the hub
until the thread engages with the dropout.
Tighten the axle firmly with a tightening torque
of 12 Nm.
WARNING
If the axle on the front or rear wheel is not fitted
correctly, the wheel may become jammed in the
suspension fork or rear triangle. This can cause
a crash or an accident.
If the axle cannot be fitted following the
instructions above, it must be checked by the
ROTWILD authorised dealer.
Fig, 51: Fitting the rear wheel axle.
NOTICE
Before you fit the axle, make sure that the thread
is clean and undamaged.
Tyres
If your tyres have cracks, some other sort of
damage or too little tread, have the tyres replaced
by your ROTWILD authorised dealer.
WARNING
Risk of accidents and injury.
If the tyre pressure
is too high or too low or if the tread is worn, the
tyres will lose their grip. Damaged tyres can burst
while you are riding.
Checking the tyres
- Use an air pump with a pressure gauge to
pump up the tyres
- to the recommended pressure.
- If the tyre pressure is too high or too low, you
must not ride your e-MTB.
- Never ride with tyres that have too little tread.
- Never ride with tyres that have cracks or other
damage caused by foreign bodies, for
example.
Wheels and tyres