3.
Use the keyboard to enter the multiplier you want
to use (
1
X is real-time).
4.
Press
MARK
+
SCROLL
again to close the menu.
To Set the Max T-Bar Speed (VAR 2)
Set the maximum speed video will move when the T-bar
is in the maximum speed position (top) and the
VAR 2
mode is active.
1.
Press
MARK
+
SCROLL
.
The
User Setup
menu opens.
2.
Use the up and down arrows, or the rotary dial, to
select
T-BAR VAR-2 MAX Speed
.
3.
Use the keyboard to enter the multiplier you want
to use (
1
X is real-time).
4.
Press
MARK
+
SCROLL
again to close the menu.
To Set the Min T-Bar Speed (VAR 2)
Set the minimum speed video will move when the T-bar
is in the minimum speed position (bottom) and the
VAR
2
mode is active.
Note:
If the minimum speed is set below 0 (negative), then a 5
degree dead-zone is applied to the mid-point in the T-bar travel.
1.
Press
MARK
+
SCROLL
.
The
User Setup
menu opens.
2.
Use the up and down arrows, or the rotary dial, to
select
T-BAR VAR-2 MAX Speed
.
3.
Use the keyboard to enter the multiplier you want
to use (
1
X is real-time).
4.
Press
MARK
+
SCROLL
again to close the menu.
To Set the Max T-Bar Speed (VAR 3)
Set the maximum speed video will move when the T-bar
is in the maximum speed position (top) and the
VAR 3
mode is active.
1.
Press
MARK
+
SCROLL
.
The
User Setup
menu opens.
2.
Use the up and down arrows, or the rotary dial, to
select
T-BAR VAR-3 MAX Speed
.
3.
Use the keyboard to enter the multiplier you want
to use (
1
X is real-time).
4.
Press
MARK
+
SCROLL
again to close the menu.
To Set the Min T-Bar Speed (VAR 3)
Set the minimum speed video will move when the T-bar
is in the minimum speed position (bottom) and the
VAR
3
mode is active.
Note:
If the minimum speed is set below 0 (negative), then a 5
degree dead-zone is applied to the mid-point in the T-bar travel.
1.
Press
MARK
+
SCROLL
.
The
User Setup
menu opens.
2.
Use the up and down arrows, or the rotary dial, to
select
T-BAR VAR-3 MAX Speed
.
3.
Use the keyboard to enter the multiplier you want
to use (
1
X is real-time).
4.
Press
MARK
+
SCROLL
again to close the menu.
To Set the Auto-mark In-point Offset
Set the timecode that is subtracted from the point of
interest (POI) timecode when saving a clip that has no
in-point.
Tip:
The auto-mark in-point is used when there is no in-point
defined and GOTO IN is pressed.
1.
Press
MARK
+
SCROLL
.
The
User Setup
menu opens.
2.
Use the up and down arrows, or the rotary dial, to
select
AUTO-MARK IN
.
3.
Use the keyboard to enter the amount of time
(minutes:seconds:frames) you want to offset from
the POI time.
58
• Replay Setup — Mira Manual (v6.1)
Summary of Contents for Abekas Mira
Page 1: ...Mira Manual v6 1 ...
