rollibot LASEREYE, User Manual

Page: 15 / 20

12
•
If the dustbin is not emptied regularly, the LaserEye may not work properly.
•
If rinsed, the large fi lter MUST be fully dried before reinstalling. If water enters the LaserEye, the vacuum may sustain serious
internal damage.
•
The exhaust fi lter should only be cleaned and/or rinsed as needed as excess maintenance may cause damage.
•
After every 3-4 full cycles, the large fi lter should be brushed, cleaned and rinsed while the small fi lters may be
brushed clean.
7.1.3 Replacing the Filter
The LaserEye comes with four preinstalled fi lters and an additional extra large fi lter for
future use. To purchase additional fi lters, please visit our website at www.rollibot.com. Filters
may be changed as needed.
Step 1.
Remove the large fi lter from the dustbin and throw it away.
Step 2.
Place a new large fi lter in the dustbin.
Step 3.
Push the dustbin back into the LaserEye.
7.2 Maintaining the Agitator Brushes
7.2.1 Removing the Agitator Brushes
Step 1:
Locate the latch at the right side of the agitator brushes and push the latch’s clip in
slightly to open it and access the rubber and bristle agitator brushes.
Step 2:
Holding up the latch, grasp and pull each brush sideways to remove.
Step 3:
Remove the end caps from the end of each brush and set them aside. If the bearings
come loose, simply reinsert them into the caps.
7.2.2 Cleaning the Agitator Brushes
Step 1:
Hold each brush over a waste bin and shake off any dust. Pull or cut out any entangled
debris. Taking care not to damage the bristles.
Step 2:
Clean around the latch if needed. Place the end caps back on the brush ends, return
them to their compartment, and close the latch. It will click into place.
1
2
End Cap
Bearing
3
1 2