4-58
20
19
21
Belt leans to the rear side of the machine
-Turn the screw 2 carefully in CW to press it to the Idle Pulley
Holder.
* Make sure to have a gap of three millimeters between the
screw 1 and Idle Pulley Holder when turning the screw 2.
Make sure not to tighten the screws too tight.
It may move the Idle Pulley Holder accidentally.
Tighten one of the screws that has no contact with the Idle
Pulley Holder to slightly touch the Idle Pulley Holder.
Tighten the two
fi
xing screws as shown in the
fi
gure.
Con
fi
rm that the belt is not touching the Pulley Flanges ex-
cessively.
When the belt is in improper position, adjust it again.
When it is proper, press [ENTER] key to cancel Aging.
SCAN
NOW AGING
[ ]
Screws
Fixing Screw
Fixing Screw
Screw 1
Idle Pulley Holder
Screw 2
Flange
Be careful with the moving Carriages during the
work, and also with the sharp edges of the mechan-
ical parts around it.
Summary of Contents for VS-300
Page 49: ...2 4 MAIN BOARD_Arrangement Diagram Soldering Side ...
Page 60: ...2 15 SERVO BOARD_Arrangement Diagram Soldering Side ...
Page 65: ...2 20 2 4 CARRIAGE BOARD CARRIAGE BOARD_Arrangement Diagram Component Side ...
Page 68: ...2 23 2 5 SUB BOARD SUB BOARD_Arrangement Diagram Component Side ...