3-104
22
No.2
No.4
No.6
No.9
No.1
No.3
No.5
No.7
No.8
No.10
23
No.3
No.4
No.6
No.8
No.7
No.9
No.7
No.8
No.9
24
Support Rail Frame
Holder Cable Plate
Fix the Ink Tubes with the three Wire Saddles shown in the
figure. Check which number of the Ink Tube is fixed to which
Wire Saddles by referring the figure.
Fix the Ink Tubes with the Wire Saddles while pushing them
backward so as not to locate the front of the Head Carriage.
If you do not fix the Ink Tubes as shown in the fig
-
ure, the Ink Tubes would pull up the Head Carriage
and the Head Carriage would be tilted.
Fix the Ink Tubes with the three Wire Saddles at the rear of
the Head Carriage. Push the Ink Tubes toward the Tube
Guide and fix them with the Wire Saddle.
When you connect the Ink Tubes, the Ink Tubes
may bend. Do not use the bent Ink Tube.
Fix the Ink Tubes with the Tube Guides to the Holder Cable
Plate and the Support Rail Frame.
When you move the Head Carriage to the center of
the machine, you can fix the Ink Tubes easily.
Summary of Contents for VS-300
Page 49: ...2 4 MAIN BOARD_Arrangement Diagram Soldering Side ...
Page 60: ...2 15 SERVO BOARD_Arrangement Diagram Soldering Side ...
Page 65: ...2 20 2 4 CARRIAGE BOARD CARRIAGE BOARD_Arrangement Diagram Component Side ...
Page 68: ...2 23 2 5 SUB BOARD SUB BOARD_Arrangement Diagram Component Side ...