26
6 Operation Guide [Cutting Section]
Maximum cutting area of the MODELA
Z-direction
X- and Y-direction
Load the Workpiece
Prepare a workpiece of the necessary size and load it on MODELA.
A block having a margin of a few millimeters larger than the minimum required size is optimal. Cutting time is long if too
large, and the solid object cannot be made if too small.
Remove the screws shown in the figure and detach the
work plate.
Bottom surface of the carriage
Work plate surface
62.4 mm (2-7/16 in.)
Workpiece thicker than this value cannot
be loaded.
In actual use, the thickness of the load-
able workpiece varies according to the
length of the mounted tool and the thick-
ness of the base.
MDX-20 : 203.2 mm (8 in.)
MDX-15 : 152.4 mm (6 in.)
MDX-20 : 152.4 mm (6 in.)
MDX-15 : 101.6 mm (4 in.)
: Maximum cutting area
The area demarcated by lines
passing through the centers
of the four holes as shown in
the figure is the suggested
maximum cutting area.