20
6 Operation Guide [Cutting Section]
Make the settings for the cutting condi-
tions.
Clicking [NEXT] advances the setting
screens in sequence from A to D.
Make the settings in order from A to D.
(Clicking A, B, C, or D in the figure
displays the corresponding setting
screen, this should not be used except
when it's necessary to make settings
independently.)
A
Select the direction of
the object
Select the direction to be
used for cutting the object.
In the figure at right, cutting
from above is selected.
B
Set the dimension
Make the setting for object's
size. Drag the spin dial up or
down, or click on a number
and enter a value from the
keyboard.
Clicking [Resize] makes it
possible to specify a ratio for
the dimensions.
C
Set the maximum cut-
ting depth
Make the setting for the
maximum cutting depth.
Drag the spin dial up or
down, or click on a number
and enter a value from the
keyboard.
Clicking [Center] sets the
depth at a location propor-
tional to the height.
D
Tool diameter/ Material/Finish
Tool
Set the type and diameter of the tool
that is installed.
Material
Choose the composition of the
loaded workpiece.
Finish
When cutting a solid object on a
modeling machine, an attractive
finish can be obtained by first per-
forming rough (draft) cutting, then
performing fine cutting. Set to [Draft]
for the first pass, and to [Fine] for the
second pass.
This displays the path of
the tool during cutting.
Click here to advance to
the next settings.
A
B
C
D
