23
6 Operation Guide [Cutting Section]
Make sure the tube is at the position shown in the figure.
Insert the cord for the spindle unit into the jack.
The Mounting Locations for the Spindle Unit
There are two locations (heights) for attaching the spindle unit.
Choose the correct location according to the cutting tool length and the thickness of the workpiece.
Load the workpiece and install the tool. When using a base to load the workpiece, mount the base as well.
Make the layout the same as for actual cutting.
Move the spindle to its highest point. When viewed from the side, if the tip of the tool is lower than the surface of the work-
piece, remount the spindle unit at the higher location.
Tube
Make sure it is at the base of the cord.
Spindle unit
Carriage
Spindle unit
Carriage
Approximately
80.6 mm (3-3/16 in.)
Spindle operating range
60.5 mm (2-3/8 in.)
Approximately
20 mm (13/16 in.)
Work plate surface
Approximately
56 mm (2-3/16 in.)
Spindle operating
range
60.5 mm (2-3/8 in.)
Approximately
116.5 mm (4-9/16 in.)
Position the connector so the arrow points
to the back of the unit and insert.
