Roland IU-1000F, Operating Instructions Manual

Page: 131 / 144

If the Machine Is to be Left Unused for a Long Time or If a Power Outage Is Scheduled
129
5. Change the pressures indicated by the pressure gauges as follows.
• Lo-1 = 0.1kPa, Hi-1 = 0.5kPa, P2 = 0.0kPa
• You can switch between the Lo-1, Hi-1, and P2 indications on a gauge by pressing the [MODE]
button. To change the indicated pressure, press the [ ] and [ ] buttons.
• Set the Lo-1 and Hi-1 pressures indicated by both gauges to the same value. Do likewise for the P2
pressures.
6. Click [Discharge] in the "Ink Discharge/Charge" area.
The carriage moves to the left-side ink receiver, and then ink discharge starts.
Once discharge ends, the message "Discharged" appears. Of the sub tank ink levels indicated at the
lower right of the screen, the sub tank of the discharged ink flashes in red.
7. Next, discharge the ink in the following order. Check 2 colors at a time, specify "Discharge
time (Sec)", and then execute [Discharge].
If the ink configuration is set to "Standard Ink Config"
Cyan and Magenta (Discharge time: 60 sec) Yellow and Black (Discharge time: 60 sec) Gloss
and Primer (Discharge time: 60 sec)
If the ink configuration is set to "Double White Ink Config"
Cyan and Magenta (Discharge time: 60 sec) Yellow and Black (Discharge time: 60 sec) White2
(Discharge time: 30 sec)
After the ink for all colors becomes "Discharged", go to the next step.