Roland IU-1000F, Operating Instructions Manual

Page: 113 / 144

If a Message Appears
111
Message Cause Solution
119: "Setting up channel
mapping has failed."
"Contact your equipment
provider, please!"
An error has occurred in the
carriage card of the controller
software of the machine.
Turn the power to the machine
off and then on again. If the same
message still appears, contact
your authorized Roland DG
Corporation representative.
120: "Restart has been cancelled
by user, position system does not
work correctly, please do not
execute the carriage motion."
As the reset operation on the
machine was canceled,
initialization of the carriage
position failed.
Restart Print Control. Do not
perform any other operations
while Print Control is restarting.
121: "Limit position signal cannot
be detected after machinery
reset. Reset has failed. Position
system is not working correctly."
"Contact your equipment
provider, please!"
There is a problem with the
carriage system of the machine.
Turn the power to the machine
off and then on again. If the same
message still appears, contact
your authorized Roland DG
Corporation representative.
122: "When doing reset, there is
no carriage encoder signal, and
can’t execute reset function."
"Please confirm interlock switch
and restart software. If the
device do not recover, please
contact your equipment
provider."
• The machine's front cover
or another cover is open.
• The carriage is positioned
too far to the left or right
end.
• Close the cover properly,
and then reboot Print
Control.
• Move the carriage by hand
approximately 10 cm
toward the center, and then
reboot Print Control.
If the same message appears
even after this is performed, turn
the machine off and on. If the
same message still appears,
contact your authorized Roland
DG Corporation representative.