What to Do If
Chapter 4 Appendix
62
that you have specified may exceed the capabilities of the machine. Check the cutting parameters.
P. 6, "Starting and Shutting Down the Machine," p. 43, "Replacing the Spindle Motor"
The spindle rotation was stopped for either of the following reasons.
High motor load state continued, or instant excessive torque was applied.
The spindle motor is not installed.
Follow the on-screen message to check the spindle motor condition.
If the symptoms arise again even after you have replaced or installed the spindle motor, the cutting operation
that you have specified may exceed the capabilities of the machine. Check the cutting parameters.
P. 28, "Saving and Reusing Output File Lists"
This is displayed in the following cases.
When a file in an output file list was opened, the specified file did not exist.
When a file in an output file list was selected, the specified file did not exist.
When the [Output] button was clicked, the files in the list did not exist.
Check the files in the output file list.
P. 28, "Saving and Reusing Output File Lists"
The spindle rotation is stopped.
The spindle motor experienced an excessive load
or it is not mounted.
Confirm whether the spindle motor is mounted.
Revise the cutting method.
@@@@@@@ not found.
Summary of Contents for iModela iM-01
Page 73: ...R2 111104 DOC 0943 ...