63
Chapter 4 Appendix
NC Code Specifications
List of Settings Related to NC Code
The following list contains the settings related to interpreting and executing NC code that can be performed
on the machine. Use NC programs to perform all other settings.
See the "NC Code Reference Manual."
NOTE: If you want to make settings related to NC code, set the command set to "NC Code" or "RML-1/NC
Code."
P. 10, "Selecting the Command Set"
Numeric Value Interpretation Method
Select the interpretation method for numeric values with a decimal point and the calculator interpretation
range. On the iModela Controller, click [Setup] and then [NC Code setting]. Then set these values on the NC
Code tab.
For details on these settings, see the iModela Controller's Help.
P. 3, "Viewing the Documentation for the Software"
Workpiece Origin Offset (G54 to G59)
This setting is related to the location of the origin of the workpiece coordinate system. Select the coordinate
system that you want to set under Set Origin Point on the iModela Controller, and then set the origin. You can
also use NC programs to set the G10 and G92 coordinate systems.
EXOFS
Follow the setting method described below.
1. Set the display of the coordinate system on the iModela Controller to "Machine Coordinate System."
2. Click the feed buttons on the iModela Controller to set the X, Y, and Z coordinates.
3. Set the coordinate system under Set Origin Point to "EXOFS."
4. Set the X/Y origin and the Z origin.
You can also use NC programs to set the G10 coordinate system.
Cutter Diameter Compensation Value
On the iModela Controller, click [Setup] and then [NC Code setting]. Then set this value on the Tool-diameter
Offset tab. You can also use NC programs to set the G10 coordinate system.
Cutter Diameter Compensation Type (G41, G42)
Select type A or type B. On the iModela Controller, click [Setup] and then [NC Code setting]. Then set this
value on the NC Code tab.
Optional Block Skip (/)
Enable or disable the optional block skip feature. On the iModela Controller, click [Operation Settings] and
then [NC Code setting]. Then set this value on the NC Code tab.
Summary of Contents for iModela iM-01
Page 73: ...R2 111104 DOC 0943 ...
