62
Chapter 5 Using Pedals to Control the Effects
Wave Pedal
This changes the parameter selected as a target in a certain
cycle with the assumed EXP pedal. When you have set
“Wave Pedal” for “Source,” the following parameters should
be set.
* The following targets cannot be operated with the Wave pedal.
• FX1/FX2 Select (FX-1, FX-2)
• Type (Preamp/Speaker, Overdrive/Distortion, Delay)
You may be unable to change parameter settings when
the following functions are set for the target while
INTERNAL PEDAL or WAVE PEDAL is selected for the
source.
• TUNER On/Off
• MANUAL On/Off
• Patch Num. Inc
• Patch Num. Dec
• Patch Bank Inc
• Patch Bank Dec
Note that if you inadvertently happen to make this type
of setting, there is no way to return the patch to its
normal state other than overwriting and saving.
MIDI CC#1–31,64–95
This is activated when the value of the Control Change messages
(CC#01–31, 64–95) from an external MIDI device exceeds the middle
value.
Time
fig.05-220d
0–100
This controls the time needed for the as-
sumed Expression pedal to move from the
returned (lifted) position to the depressed
(lowered) position.
Curve
fig.05-230d
see below
This selects one of the three types that deter-
mines how the assumed Expression pedal
changes.
fig.05-240
Parameter/
Range
Explanation
Linear
Slow Rise
Fast Rise
Parameter/
Range
Explanation
Rate
fig.05-250d
0–100
This determines the time spend for one cycle
of the assumed EXP pedal.
Waveform
fig.05-260d
see below
This selects one of the three types that deter-
mines how the assumed EXP pedal should
change.
fig.05-270
SAW
TRI
SIN
GT-8_e.book 62 ページ ２００７年６月２９日 金曜日 午後３時５５分
