82
Chapter 8 Using the GT-8 with External MIDI Devices Connected
When Transmitting Data to Another GT-8
Connect as shown in the figure below, and match the Device
ID for the transmitting and receiving devices.
fig.08-150
Transmitting
fig.08-160
1.
Press [SYSTEM] twice, then press PARAMETER [
]
[
] so that “MIDI: Bulk Dump” is displayed.
fig.08-170d
2.
Press PARAMETER [
] [
] to move the cursor,
and rotate the PATCH/VALUE dial to select the start
and end of the data to be transmitted.
3.
When the data to be sent has been determined, press
[WRITE].
The data is transmitted.
fig.08-180d
When the transmission is completed, the screen prior to
transmission returns to the display.
4.
Press [EXIT] to return to the Play screen.
Receiving Data from an External
MIDI Device (Bulk Load)
Making the Connections
When Receiving Data Saved on a MIDI Sequencer
Connect as shown below. Set the GT-8’s Device ID to the
same number that was used when the data was transmitted
to the MIDI sequencer.
fig.08-190
For instructions on operating the sequencer, refer to the
owner’s manual for the sequencer you are using.
Receiving
fig.08-191
1.
Press [SYSTEM] twice, then press PARAMETER [
]
[
] so that “MIDI: Bulk Load” is displayed.
MIDI OUT
MIDI IN
1
1,2
4 3
MIDI IN
MIDI OUT
1,2
3
GT-8_e.book 82 ページ ２００７年６月２９日 金曜日 午後３時５５分
