42
Chapter 4 Introduction to Effects and Parameters
WSY (Wave Synth)
This is a synth sound that processes the guitar input signal.
SEQ (Sub Equalizer)
This adjusts the tone as a sub equalizer. A parametric type is
adopted for the high-middle and low-middle range.
Parameter/
Range
Explanation
Wave
Saw, Square
Selects a wave type which the synth sound
is based.
Saw
Creates a synth sound with a saw waveform (
).
Square
Creates a synth sound with the square waveform (
).
Cutoff Freq (Cutoff Frequency)
0–100
Adjusts the frequency where the harmonics
contents of the sound are cut off.
Resonance
0–100
This adjusts the amount of resonance (and
the tone coloration) in the synth sound.
The higher the value, the more the synth tone coloration is empha-
sized.
FLT.Sens (Filter Sensitivity)
0–100
This adjusts the amount of filtering applied
in response to the input.
FLT.Decay (Filter Decay)
0–100
This sets the time needed for the filter to fin-
ish its sweep.
FLT.Depth (Filter Depth)
0–100
Adjusts the depth of the filter.
When the value is higher, the filter will change more drastically.
Synth Level
0–100
Adjusts the volume of the synth sound.
Direct Level
0–100
Adjusts the volume of the direct sound.
Parameter/
Range
Explanation
Low Cut (Low Cut Filter)
Flat, 55 Hz–800 Hz
This sets the frequency at which the low cut
filter begins to take effect.
This lets you cut the low-end component below the set frequency to
create a clear, distinct low end, thereby bringing out the high end of
the effect. When “Flat” is selected, the low cut filter will have no ef-
fect.
Low EQ
-20 dB–+20 dB
Adjusts the low frequency range tone.
Low-Middle Frequency
20.0 Hz–10.0 kHz
Specify the center of the frequency range
that will be adjusted by the “Low-Middle
EQ.”
Low-Middle Q
0.5–16
Adjusts the width of the area affected by the
EQ centered at the “Low-Middle Frequen-
cy.”
Higher values will narrow the area.
Low-Middle EQ
-20 dB–+20 dB
Adjusts the “Low-Middle Frequency” range
tone.
High-Middle Frequency
20.0 Hz–10.0 kHz
Specify the center of the frequency range
that will be adjusted by the “High-Middle
EQ.”
High-Middle Q
0.5–16
Adjusts the width of the area affected by the
EQ centered at the “High-Middle Frequen-
cy.”
Higher values will narrow the area.
High-Middle EQ
-20 dB–+20 dB
Adjusts the “High-Middle Frequency”
range tone.
High EQ
-20 dB–+20 dB
Adjusts the high frequency range tone.
High Cut (High Cut Filter)
700 Hz–11.0 kHz, Flat
This sets the frequency at which the high cut
filter begins to take effect.
This allows you to get a mild effect sound by cutting the high-end
component above the set frequency. When it is set to “Flat,” the high
cut filter is off or has no effect.
Level
-20 dB–+20 dB
Adjusts the volume before the equalizer.
GT-8_e.book 42 ページ ２００７年６月２９日 金曜日 午後３時５５分
