Installing a Cutter
In the 3D Cutting mode, you install a cutter before you load material.
Press the power button to turn on the power.
The carriage moves to the right edge and the table moves to the front, the unit goes into View status, and
the Power and View lights light up.
Press the View button.
The spindle unit and table move, and the spindle unit moves to above the origin point on the table.
When movement ends, the View light goes dark.
Use the movement button on the switch panel to
move the spindle unit to about the center of the
table.
Press and hold the center of the movement button
for a short while (0.6 second or more).
The Z-axis light illuminates, indicating that it is now possible
to move the spindle unit up and down.
Press the lower part of the movement button.
The spindle unit descends while you hold down the button.
Hold down the movement button until the spindle unit
stops automatically.
The spindle unit stops,
leaving a small gap.
Press up, down, or
to the left or right.
Press.
Press.
30
4 Creating a Relief (3D Cutting Mode)
Summary of Contents for EGX-20
Page 51: ......
