Press the Origin Set button on the
switch panel.
The spindle unit descends by 0.5 mm and
the Origin Set light lights up.
Insert the cutter into the hole in the
cutter holder, then slowly lower the
cutter.
Lower until the cutter touches the plate.
Use the included hexagonal screw-
driver to tighten the retaining screw
for the cutter holder.
Tighten secure so that the cutter does not
come loose during engraving.
Press the Origin Set button on the
switch panel.
The spindle unit rises 0.5 mm and the Origin
Set light goes dark.
NOTICE
Before you install a cutter, install the cutter
holder.
P. 11, "Installing the Cutter Holder"
Press.
Press.
18
3 Creating a Nameplate (Engraving Mode)
Summary of Contents for EGX-20
Page 51: ......
