Periodic Maintenance
38
3. Maintenance
Correcting the Milling Machine
The accuracy of the milling machine may vary if it is used for a long period of time or the surrounding environment changes.
With automatic correction, the ATC magazine and the rotary axis will be in the right position.
Cases Where You Need to Perform this Task
When you finish installing the machine
When you finish moving the machine
When the cutting position is misaligned
When there is a level difference or a hole is created in the Z direction, etc. in cutting result
Required Items
·Detection pin · Automatic correction jig ·Torque driver · Cloth for care
1.
Install the detection pin.
Clean off any milling waste around the clamp.
P. 34"Cleaning after Milling Finishes"
Use the supplied cloth for care to clean the detection pin, automatic correction jig, and central
protrusion on the ATC magazine.
If any dirt is affixed, correction might not occur properly.
Install the detection pin to the ATC magazine's No. 10 position.
OK
Not OK
Insert the detection pin firmly.
Detection pin
Central protru-
sion on the
ATC magazine
Detection pin
Clean the tip
as well
Also wipe the
rear side.
Automatic correction jig
Part to be wiped (Detection point )
Summary of Contents for DWX-51D
Page 64: ...R2 160616 FA01061 ...
