Responding to Error Messages
61
4. Troubleshooting
Error number
Message
Situation/error cause
Action
101E-****
The % milling bur
might be broken.
(% may be "1 to
10")
The milling bur might be
broken.
1. Press and hold the operation button on the
built-in panel to clear the error.
2. If the milling bur is broken, replace it with a
new one.
3. If the position of the milling bur holder is not
appropriate, correct the position.
P. 26"STEP 2: Attaching the Milling Bur"
The milling bur holder
might be out of position.
The milling conditions
may be excessively strict.
1. Press and hold the operation button on the
built-in panel. This will clear the error.
2. Review the CAM settings and the shape
specified in the CAD data.
The collet may be worn
out.
If the error occurs again even after you perform
the above operations, the collet may have
worn out, leading to a decrease in its retention
capabilities. Replace the collet with a new one.
101F-****
T h e % m i l l i n g
bur chucking has
slipped out.
(% may be "1 to
10")
The collet may have
come loose.
1. Press and hold the operation button on the
built-in panel to clear the error.
2. Retighten the collet.
P. 41"Retightening the Collet"
The milling conditions
may be excessively strict.
1. Press and hold the operation button on the
built-in panel. This will clear the error.
2. Review the CAM settings and the shape
specified in the CAD data.
The collet may be worn
out.
If the error occurs again even after you perform
the above operations, the collet may have
worn out, leading to a decrease in its retention
capabilities. Replace the collet with a new one.
1020-****
1021-****
The % milling bur
is too long.
The % milling bur
is too short.
(% may be "1 to
10")
There is a possibility
that the position of the
milling bur holder is not
correct.
Replace the milling bur with one of the appropri-
ate length (40 to 55 mm). Also check the position
of the milling bur holder.
P. 26"STEP 2: Attaching the Milling Bur"
1022-****
The % milling bur
is not found.
(% may be "1 to
10")
The milling bur has
not been set or it may
have been mounted
on an incorrect stocker
number.
1. Set the milling bur in the correct position
again.
If milling is in progress
Close the front cover, and press and hold the
built-in panel's operation button. Resume
milling.
There is a possibility that
the ATC magazine is out
of position.
Perform automatic correction.
P. 38"Correcting the Milling Machine"
The collet may be worn
out.
Replace the collet.
If the error occurs again even after you perform
the above operations, replace the spindle unit
with a new one.
Summary of Contents for DWX-51D
Page 64: ...R2 160616 FA01061 ...