Roger Technology CTRL, Instruction And Warnings For The Installer

Page: 87 / 292

EN
87
PROBLEM ALARM SIGNAL POSSIBLE CAUSE CORRECTIVE ACTION
Acquisition proce-
dure does not com-
plete correctly.
QR 3+
Motor calibration failed. Repeat acquisition procedure.
If the problem persists, check the cable connecting
encoder 1 to the motor.
Check that the motor turns without impediment. Contact
technical support in case of any problems.
$3 3( TEST button pressed accidentally. Repeat acquisition procedure.
Safety devices in alarm state.
Check connections of safety devices.
Excessive voltage drop. Repeat acquisition procedure; check mains voltage.
Barrier does not
perform desired
manoeuvre. Incorrect setting of parameter . Select the correct installation position with parameter
. Repeat acquisition procedure.
The barrier opens/
closes for a short
distance and then
stops.
Incorrect setting of parameter $ . Check type of boom and set parameter $ correctly.
Repeat acquisition procedure.
Incorrect values for installation
type. Set values of parameters , , and correctly
for installation type.
Incorrect spring setting. See the barrier instructions for spring balancing.
E RG Battery operation management
(par.
different than ) not
detected.
Change the value of the parameter .
The remote control
has limited range
and does not work
with the automation
moving. Radio signals are impeded by
metal structures and reinforced
concrete walls. Install the antenna.
Flat batteries. Replace the radio control batteries.
The flashing light is
not working. Bulb / LED blown or flashing light
wires disconnected. Check LED circuit and/or connector wires.
Barrier open indi-
cator lamp does
not work. Bulb blown or wires disconnected. Check the bulb and/or wires.
N.B. : Press the TEST button to temporarily cancel the alarm.
The next time a command is received, the alarm reappears on the display if the problem has not been resolved.