Roger Technology CTRL, Instruction And Warnings For The Installer

Page: 73 / 292

EN
73
12
Index of parameters
PARAM.
FACTORY
DEFAULT
DESCRIPTION PAGE
$
Enable RS485 serial communication (MASTER-SLAVE) 75
$
Barrier model and the length of the boom selection 75
$
Automatic closing after time pause (from barrier completely open position) 75
$
Automatic closing after mains power outage 75
$
Step mode control function selection (PP) 76
$
Pre-manoeuvre flashing warning 76
$
Condominium function for partial open command (PED) 76
$
Enable "operator present" function 76
$
Barrier open/photocell test function and battery saving mode indicator lamp 76
Enable the B73/EXP signal device to indicate barrier completely open/closed
positions
76
Setting deceleration during opening 77
Setting deceleration during closure 77
"BreakAway" ACS/BA/60 detachable boom coupling system enabling 77
SC output operating mode 77
Setting automatic closing time 77
Enabling of management for opening with automatic re-closure exclusion 77
Enable electric lock 77
Obstacle detection time setting (crush prevention) 78
Setting opening start acceleration 78
Setting closure start acceleration 78
Opening speed setting 78
Closure speed setting 78
Approach speed setting 78
Opening approach distance setting 78
Closing approach distance setting 78
Number of automatic closure attempts after activation of sensing edge or
obstacle detection (crush protection)
78
Photocell mode for barrier opening (FT) 78
Photocell mode for barrier closure (FT) 78
Photocell (FT) mode with barrier closed 79
Enable close command 6 s after activation of photocell (FT) 79
Motor stop distance setting 79
Installation position of barrier relative to gateway (seen from the inspection hatch
side).
79
Sensing edge COS configuration 79
Radio channel 1 configuration (PR1) 79
Radio channel 2 configuration (PR2) 79
Flashing light / upper cover lights frequency configuration 79