Roger Technology CTRL, Instruction And Warnings For The Installer

Page: 82 / 292

EN
82
Identification number
The identification number consists of the values of the parameters from Q to Q .
N.B. : The values shown in the table are indicative only.
Q
HW version
Example:
Q
Year of manufacture
Q
Week of manufacture
Q
Serial number
Q
Q
Q
FW version
Q
RS485 serial communication version
View manoeuvre counter
The number consists of the values of the parameters from
R
to
R
multiplied by 100.
N.B. : The values shown in the table are indicative only.
R
Manoeuvres performed
Example: x100 = 1,234,500 manoeuvres
R
R
View manoeuvre hour counter
The number consists of the values of the parameters from K to K .
N.B. : The values shown in the table are indicative only.
K
Manoeuvre hours
Example: = 123 hours
K
View control unit days on counter
The number consists of the values of the parameters from G to G .
N.B. : The values shown in the table are indicative only.
G
Days with unit switched on
Example: = 123 days
G
Password
Setting a password prevents unauthorised persons from accessing the settings.
With password protection active (
&3 = ), parameters may be viewed but the values CANNOT be modified.
Only a single password is used to control access to the barrier automation system.
WARNING: Contact the Technical Support Service if you lose your password.
N.B.: This parameter is not visible for the SLAVE barrier.
3
3
3
3
Password activation procedure:
• Enter the desired values for parameters
3
,
3
,
3
and
3
.
• Use the UP
a
and/or DOWN
b
buttons to view parameter
&3
.
• Press and hold the
+
and
-
buttons for 4 seconds.
• The display flashes to confirm that the password has been saved.
• Switch the control unit off and on again. Check that password protection is activated (
&3
= ).
Temporary unlock procedure:
• Enter the password.
• Check that
&3
= .
Password cancellation procedure:
• Enter the password ( &3 = ).
• Save the values
3
,
3
,
3
,
3
=
• Use the UP
a
and/or DOWN
b
buttons to view parameter
&3
.
• Press and hold the
+
and
-
buttons for 4 seconds.
• The display flashes to confirm that the password has been cancelled (the values 3 , 3 , 3 and 3 and
indicate that no password is set).
• Switch the control unit off and on again ( &3 = ).
&3 Password change protection
Protection deactivated.
Protection activated.