External Tool Finishing Kit - Instruction Manual
Fig. 3-4: Attaching the FT 300 sensor to a robot arm using the mandatory coupling.
Power Supply Specifications
The Sensor needs to be supplied by a DC voltage source. This power supply is not included with the Sensor. When installing, use the
24 Volt external source available on the CB-Series controller.
POWER SUPPLY SPECIFICATIONS
VALUE
Output voltage
5 to 24 V DC
Max power consumption
2 W
Overcurrent
1 A Fuse (Phoenix #0916604 (UT6-TMC M 1A))
Overvoltage protection
Warning
Maximum output voltage tolerance is 10%, exceeding this
limit, 26.4 V DC could damage the Sensor.
Info
Robotiq recommends the use of the following power supply:
TDK-Lambda DPP Series, 15W Single Output DIN Rail Mount Power Supply, DPP15-24
21