RoboJet Air AH-157, Instruction Manual & Warranty

Page: 11 / 64

EN
3. Virtual Wall
The Virtual wall create an invisible barrier that the robot will not cross.
Instructions:
1. This Virtual Wall is powered by 2 batteries (included).
2. To turn on the Virtual Wall, slide the power switch to “ON” position.
3. When turned on, the blue LED light glows, then the Virtual Wall turns into waiting mode.
4. The best effective distance of Virtual Wall barrier is about 3m (10 ft.)
5. The LED light will blink when the Virtual Wall is low on battery.
You can charge battery by plugging into charging base, please see the figure above.
Step 1: The power switch of Virtual Wall must set to “ON” position.
Step 2: Press and slide out the DC Plug from charging base.
Step 3: Plug the DC Plug into DC Inlet, the LED light will blink.
Step 4: When recharge is complete, LED will glow continuously.
 When the robot is cleaning, the Virtual Wall must position at least 3m (10 ft.) away from
Charging Base, and avoid facing towards Charging Base.
 When the robot completes cleaning, you can power off the Virtual Wall by sliding the power
switch to “OFF” position.