RoboJet Air AH-157, Instruction Manual & Warranty

Page: 9 / 64

EN
2. Recharging Home Base
When the robot completes its cleaning cycle or the battery charge level is 10%, the robot will return to
the Recharging Home Base automatically.
Installation
1. Position Home-base on an even floor surface against wall
2. Position it at location with at least a 0,6 m
(2 ft.) clearance around.
3. Connect the AC adaptor to the power
socket on the rear side. Only use the AC
adaptor provided
4. Always keep the Recharging Home Base
power plugged in.
Docking Test
1. Leave the robot on the floor somewhere
near the Recharging Home Base.
2. Press the “Home” button on the remote control.
3. The robot will return to the Recharging Home Base automatically.
4. If the robot fails to dock, check the installation process to make the necessary adjustments to
the Recharging Home Base until the robot can dock properly.
Pairing the Robot with Recharging Home Base
1. Keep press UV button until display show Cd.
2. Press Time button on Recharging Home Base, you will hear signal twice and the VAC button will
blinks. Pairing completed with success.
Robot Battery Recharge
 When The Power Button on the robot blinks red, this indicates that the battery level is low.
 The robot will shut down the vacuum engine and go back to the Recharging Home Base.
 Users can also use the AC adaptor to plug into the robot directly to recharge the battery.
 When the battery is fully recharged, the Power Button will light up a solid blue. The recharging
process is about 3 hours.