BLACK+DECKER and the BLACK+DECKER logos are trademarks of The Black & Decker
Corporation, used under license by Spectrum Brands, Inc. for its manufacturing and sale of
this product. All rights reserved.
BLACK+DECKER et les logos BLACK+DECKER sont des marques de commerce de Black &
Decker Corporation, utilisées sous licence par Spectrum Brands, Inc. pour la fabrication et
la vente de ce produit. Tous droits réservés.
At the end of this product’s life,
you can mail it to Spectrum Brands at
507 Stokely Drive, Deforest, WI 53532
marked “Product Takeback: Please Recycle!”
À la fin de la durée utile de ce produit,
vous pouvez le poster à Spectrum Brands au
507 Stokely Drive, Deforest, WI 53532
en indiquant sur la boîte
« Product Takeback: Please Recycle! »
Made in China.
Fabriqué en Chine.
© 2021 Spectrum Brands, Inc., Middleton, WI 53562
All rights reserved.
E/F 28511
T22-9002292-A
Please Read and Save this Use and Care Book.
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be followed, including the following:
• READ ALL INSTRUCTIONS BEFORE USING.
• To reduce the risk of contact with hot water emitting from steam vents, check appliance
before each use by holding it away from body and operating steam button.
• Use steamer only for intended use.
• To reduce the risk of electric shock, do not immerse the steamer in water or other liquids.
• Always turn the unit off before plugging or unplugging the unit from the electrical outlet.
• Never pull on the cord to disconnect from the electrical outlet; instead grasp plug and pull to
disconnect.
• Do not allow cord to touch hot surfaces. Let steamer cool completely before putting away.
Loop cord loosely around appliance when storing.
• Always unplug steamer from the electric outlet before filling with water, emptying, or
cleaning, and when not in use.
• Do not operate the steamer with a damaged cord, or if the appliance has been dropped
or damaged, or if it is leaking. To reduce the risk of electric shock, do not disassemble or
attempt to repair the steamer; take it to a qualified service person for examination and
repair, or call the appropriate toll-free number in this manual. Incorrect reassembly or repair
could cause a risk of fire, electric shock, or injury to persons when the steamer is used.
• Close supervision is necessary for any appliance being used by or near children. Do not
leave the steamer unattended while connected.
• Burns can occur from touching hot water or steam. Appliance should not be turned upside
down – there may be hot water in the reservoir. Avoid rapid movement of steamer to
minimize hot water spillage.
• To reduce the likelihood of circuit overload, do not operate another high wattage appliance
on the same circuit.
• If an extension cord is absolutely necessary, a minimum 10-ampere rated cord should be
used. Cords rated for less amperage may overheat. Care should be taken to arrange the
cord so that it cannot be pulled or tripped over.
• Do not use outdoors.
• Do not use anything other than water in the steamer while in use or during cleaning.
• Never steam clothing while on a body.
• Never aim the steam directly towards people, animals or plants. The steam is very hot and
can results in burns. Burns can occur from touching hot parts (including the steamer head
and frames), hot water, or steam.
• This unit should be used in an upright position only. Never hold the steam head down while at
rest or tilt it as this may result in hot water discharge and possibly injury.
• This appliance is not intended for use by persons (including children) with reduced physical,
sensory, or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliances by a person responsible for
their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• The steamer must be used and rested on a stable surface.
SAVE THESE INSTRUCTIONS.
This product is for household use only.
POLARIZED PLUG (120V models only)
This appliance has a polarized plug (one blade is wider than the other). To reduce the
risk of electric shock, this plug is intended to fit into a polarized outlet only one way. If
the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact
a qualified electrician. Do not attempt to modify the plug in any way.
Note: If the power supply cord is damaged, in order to avoid a hazard, it should be
replaced by qualified personnel.
TAMPER-RESISTANT SCREW
Warning: This appliance is equipped with a tamper-resistant screw to prevent removal
of the outer cover. To reduce the risk of fire or electrical shock, do not attempt to
remove the outer cover. There are no user-serviceable parts inside. Repair should be
done only by authorized service personnel.
PARTS AND FEATURES
Product may vary slightly from what is illustrated.
GETTING STARTED
• Remove all labels, tags and stickers attached to
the body, or cord of the steamer and the plastic
band around the power plug.
• Remove and save literature.
• Please go to www.prodprotect.com/
blackanddecker to register your warranty.
• Read all the instructions before using your
steamer.
• Use distilled, purified, or filtered water. Tap
water contains minerals that build up.
• Any water droplets visible inside the tank are
from individual quality control tests.
• Do not use perfumes, oils, or other additives.
• Always review the garment manufacturer’s care
label instructions before steaming. Test fabrics
for colorfastness in inconspicuous areas (such
as an inseam). Do not use on leather, suede,
vinyl, or plastic.
• The steamer becomes hot during use.
HOW TO USE
This unit should be used in an upright position only. Do not tilt.
To fill the water tank, hold
base firmly with one hand and
the top with the other.
Replace and turn top
clockwise until the arrows
align and you feel a “click”.
Dry off excess water. Plug in
to power outlet. Press the ON/
OFF switch to ON.
Turn top counterclockwise.
Lift top off.
Pour distilled, purified, or
filtered water into opening until
water reaches the “MAX” level.
Note:
Do not use oils,
perfumes, or scented additives.
3
The steamer will take
approximately 80 seconds to
heat up and generate steam.
Hang garment against a heat/
steam proof surface.
Hold steamer by the handle
in the upright position. Do not
tilt. Hold the fabric taut while
slowly moving steamer. Keep
hands away from steam.
When done, unplug, allow
to cool, empty tank, wipe all
surfaces with a soft cloth,
reassemble, and store upright.
7
8
Customer Care Line: 1-800-465-6070
For online customer service:
www.prodprotect.com/blackanddecker
Ligne Service à la Clientèle: 1-800-465-6070
Pour le service à la clientèle en ligne :
www.prodprotect.com/blackanddecker
EASY GARMENT STEAMER
DÉFROISSEUR À VAPEUR COMPACT
use and care manual
guide d’utilisation et d’entretien
HGS011 Series
Série HGS011
1. Steam head
2. Top
3. Base
4. Handle
5. Max fill water line
6. Water tank window
7. On/Off switch
8. 8-foot cord (not shown)
1
6
2
4
5
“CLICK”
1
3
2
4
5
6
7
TROUBLESHOOTING
Problem
Possible Cause
Solution
The steamer is plugged
in but not heating.
There's a power supply issue.
Check that the plug is properly inserted into
the outlet or try plugging the steamer into a
different outlet.
Not enough steam or
no steam is coming out
of the steamer.
The steamer isn’t heated up
to full temperature.
Always allow steamer to preheat at least 80
seconds.
There is not enough water in
the water tank.
Follow the instructions under the “filling
the water tank” section and fill to Max level
marker.
Calcium deposits have built
up.
Follow the instructions under TIPS on how “To
decalcify steamer”.
Discolored water is
coming through the
holes and staining the
fabric.
Residue has built up in the
water tank.
Empty the water tank after each use. Only use
distilled, filtered, or purified water.
Perfumed or scented
additives were used.
Regularly clean steamer and refrain from
using perfumed or scented additives.
Steamer is leaking or
spitting.
Steamer is not hot enough.
Allow the steamer to heat for about 80
seconds.
Condensation has built up.
Gently wipe the steam head with a soft, damp
cloth to remove condensation.
Water tank is running low.
Follow the instructions in the “How to Use”
section and fill to Max level marker.
TIPS
• Sensitive items
(such as items with
embellishments)
should be steamed
from the inside of
the garment to avoid
damage.
• Allow clothing to cool
for about 5 minutes
after steaming to set
the press.
•
To decalcify steamer
,
mix 1/2 white vinegar
with 1/2 water. Plug
in steamer and run
half of the solution
through the steamer.
Unplug and let it sit
for 30 min. Dump
out. Repeat as
needed until steam
output improves. Run
fresh water through
steamer before using
on clothes.
CLEANING AND CARE
This product contains no user serviceable parts. Refer to
qualified service personnel.
CLEANING STEAMER EXTERIOR
1. Make sure steamer is unplugged and completely cool.
2. Wipe the outer surface with soft, damp cloth. Water
and small amounts of gentle household soaps, such as
dishwashing liquid, can be used on the exterior. Never use
heavy-duty cleaner, or abrasive scouring pads that may
scratch or discolor the steamer.
3. After the steamer has been thoroughly dried, turn it
back on and lightly steam over an old cloth. This will help
remove any reside left in the steam holes.
REMOVING MINERAL BUILDUP
1. Make sure steamer is unplugged and completely cool.
2. Mix together half a cup of vinegar with half a cup of water.
3. Remove steamer head and slowly pour mixture into
the opening.
4. Run the steamer until half of the mixture is gone. Let rest
for 30 minutes and pour out.
5. Rinse water tank with water and replace steamer head.
STORING THE STEAMER
1. Check that the steamer is unplugged and completely cool.
2. Wrap the cord loosely around the base of the steamer.
3. Always store steamer upright on its base to prevent
water leakage.
Tip:
Emptying the tank after each use is recommended
because standing water can leave a residue over time.
