Quick start guide for the AmbiCube
for the initial installation
1.
2.
Date: 17.02.2021 | Version 2 | en | Subject to technical changes
Keller Lufttechnik GmbH + Co. KG Neue Weilheimer Straße 30 73230 Kirchheim unter Teck +49 7021 574 0 [email protected]
Bring the device into the required position.
Close all parking brakes and turn inward.
NOTE:
The device should be positioned as centrally as possible within the room,
so that the air exchange can proceed evenly. Should this not be possible
and one side of the device is positioned against a wall, the slats of the air
inlet on this side must be closed manually as much as possible.
Plug the device into the power supply as follows:
Plug the power supply cable into the power connector of the device.
Plug the power supply cable into the power socket.
3.
Which setting mode should be selected on the knob?
This actually depends on the ambient volume and the number of air
changes per hour.
For this reason, first specify the room volume by measuring the length, width
and height of the room.
The appropriate setting mode for the room can then be selected by referring
to the table at the bottom of the back panel.
NOTE:
In general, it is recommended that the room air is changed 4 to 6 times per
hour to ensure the best cleaning effect.
This means that the entire room air is filtered 4 to 6 times per hour.
4.
Place the provided sticker above the control
knob on the front of the device. Note the
settings you have just determined for 4 and 6
air changes per hour on the sticker. This will
enable each person to set the device
correctly.
5.
NOTE!
Always make sure that no objects are placed on the discharge grille on the
top of the device, especially before switching it on.
No liquid or moisture may get into the device, as this will destroy the filter
elements.
