1 Introduction
Manual ENCO 08-M · EN05 · 2018, September 10th
8
These risks have been considered during the development phase and action were
taken to minimize these risks.
Danger
Working in hazardous areas
For work in hazardous areas (all zones):
•
Only tools approved for Ex Zone 1 may be used for maintenance and repair
work. Components can be damaged if you do not use the appropriate tool.
The explosion protection expirees
•
Otherwise work may only be carried out if there is no potentially explosive
atmosphere.
•
A risk of ignition caused by impact or friction must be avoided.
•
In hazardous areas, the wiring and installation of the ENCO 08 encoder
may only be carried out by trained personnel in accordance with EN60079-
14 and in compliance with national regulations.
•
Qualified personnel are persons according to DIN VDE 0105 or IEC 364 or
directly comparable standards
•
Only use trained and instructed personnel. Work on the measuring system
may only be carried out by qualified persons and must be checked by
responsible specialists.
•
Qualified persons have been authorized to carry out such work by the
person responsible for the safety of man and plant on the basis of their
training, experience or instruction and their knowledge of relevant
standards, regulations, accident regulations and plant conditions. It is
crucial that these persons are able to recognize and avoid possible dangers
in good time.
1.2.6
Validity of the manual
This manual describes the transmitter unit ENCO08 u. ENCO08-M. This encoder
is only a part of a complete on-site system. Observe also the instructions of other
components of the site system. If you find contradicting instructions, please
contact RMG.
