1 Introduction
Manual ENCO 08-M · EN05 · 2018, September 10th
6
Since the operation of the ENCO 08 encoder does not have to do directly, but only
indirectly, with pressurized pipelines, no further warnings in this respect are listed
here. If necessary, contact the operator of the plant for further information.
Notice:
•
The ENCO 08 encoder may only be connected in an explosion-free,
depressured atmosphere. Observe the descriptions in the operating
instructions during the installation process.
•
In general, it is recommended that an ENCO 08 encoder should only be
installed, connected or replaced by RMG Service.
•
All the above points also apply to repair and maintenance work and
generally when connecting or disconnecting the ENCO 08 encoder is
required.
1.2.4.3
Danger when using, servicing and maintaining
Operating personnel
The operating personnel are to use and operate the
device within the scope of the intended purpose.
Maintenance personnel
Work on the device must only be carried out by specialist
personnel that can carry out the respective work assigned
to them as a result of their training, knowledge and
experience as well as the applicable regulations. These
specialist personnel are familiar with the legal guidelines
for accident prevention and can evaluate and avoid
possible risks by themselves.
Maintaining and cleaning
Maintenance and cleaning must only be carried out by the
respectively qualified specialist personnel.
Danger
If staff carry out work without sufficient qualification, risks may be
underestimated when working. Explosion or fire may happen. If work is
carried out in hazardous areas on voltage supporting equipment, resulting
sparks may cause an explosion.
Only carry out the work if you have the appropriate qualifications and are
a trained specialist.
