1 Introduction
Manual ENCO 08-M · EN05 · 2018, September 10th
4
Caution
All notes in the manual must be observed.
Always keep the operating instructions within reach for use at the place of
installation.
For safe operation, the safety instructions must be observed and followed.
The manufacturer is not responsible for any damage that result as a
consequence of not observing the operating instruction.
Danger
Service and maintenance work or repairs that are not described in the
operating instruction must not be carried out without previous
consultation with the manufacturer.
Changes of the Encoder ENCO 08 are forbidden.
1.2.4.2
Hazards during commissioning
Initial start up
Initial start-up must only be carried out by especially
trained personal (training by RMG) or by service personal
from RMG.
Notice
In accordance with §15 BetrSichV "Betriebssicherheitsverordnung
(industrial safety ordiance)", §5 DGUV Requirement 3 "Elektrische
Anlagen und Betriebsmittel (electrical systems and equipment)" and the
generally accepted rules of technology, especially VDE standards VDE
0100-100 "Errichten von Niederspannungsanlagen (building of low-voltage
systems)" and VDE 0165 "Electrical explosion protection", the measuring
system must be checked before commissioning the device.
Follow local or regional laws as appropriate.
An acceptance test certificate and corresponding test reports must be
prepared for this commissioning. These, the operating instructions and
the CE declaration of conformity must always be kept handy. All
documentation, including declarations of conformity and certificates,
must be checked for completeness.
