RITE-HITE FasTrax XL, Installation/Service/Owner'S Manual

Page: 58 / 92

FasTrax
®
XL
Installation/Service/Owner's Manual
Rite‑Hite
®
58 Publication: AMEN00316 2020-07-06
INSTALLATION
Final Checklist
# DESCRIPTION N/A
1 Control box conduit is mounted on the bottom
2 Ground wires properly terminated to ground terminal
3 Shield wires properly terminated to ground terminal
4 Motor ground wire terminated to lower track ground screw
5 Encoder chain/sprockets/set screws properly aligned and tightened
6 Encoder cable tightened properly
7 Lower track properly spaced
8 Lower tracks caulked
9 Lower tracks square to wall
10 Lower tracks shimmed properly if jamb cap present
11 Wall mounting brackets securely fastened to wall
12 Photoeye wires properly secured to track or wall
13 Drive tube level and evenly spaced (set screws not in keyway slot)
14 Lintel roller(s) installed properly (standard projection only)
15 Proper mounting fasteners used and anchors installed in every available mounting hole
16 Motor terminal strip securely fastened to motor bracket
17 Windbars are installed level and clear the opening when in open position, when equipped
18 Verify torque arm block mounting bolts are tightened
19 Test operation of curtain photoeye position
20 Drive and non-drive shroud installed
21 Both sets of lifting straps installed (4 per windbar), if equipped
22 NPO properly installed (optional)
23 Verify lintel seal is sealing from the curtain to the wall
24 Open and closed position adjusted properly
25 Verify counterweight does not make contact with the ground while curtain is in the open position
26
"Verify Operation" on page 61
27 Area clean of debris from installation
FSTXXL 200226