RITE-HITE FasTrax XL, Installation/Service/Owner'S Manual

Page: 30 / 92

FasTrax
®
XL
Installation/Service/Owner's Manual
Rite‑Hite
®
30 Publication: AMEN00316 2020-07-06
INSTALLATION
Motor/Encoder
Continued
I
K
J
H
6 Slide encoder drive sprocket (I) onto the primary tube
shaft DO NOT tighten the sprocket set screws yet
NOTE: If necessary, loosen the encoder bracket
mounting screws (H) to allow installation of the driven
sprocket and drive chain
7 Slide the driven sprocket (J) onto the encoder shaft
DO NOT tighten the sprocket set screws yet
8 Install encoder chain (K) around the sprockets (I, J)
L
M
9 Tighten the encoder drive chain (L) by pulling the
encoder bracket (M) forward and tightening the
encoder mounting bracket screws (H)
10 Align encoder sprockets, so the chain runs straight
Tighten the set screws in the sprockets (Figure 44)
• Tighten set screw on drive sprocket (I) using a
3/32in [2mm] Allen wrench ( DO NOT over tighten -
5lb-in [056Nm]) Sprocket does not require a key
• If removed, tighten #10-24 set screw on driven
sprocket (J) using a 3/32in [2mm] Allen wrench
DO NOT
over tighten - 5lb-in [056Nm]
O
N
11 Install the upper shroud bracket (N), using
(2) #14 x 3/4in [6mm x 19mm] hex washer head self
drill/tap screws (O)
Figure 44
Figure 45
Figure 46