RITE-HITE FasTrax XL, Installation/Service/Owner'S Manual

Page: 18 / 92

FasTrax
®
XL
Installation/Service/Owner's Manual
Rite‑Hite
®
18 Publication: AMEN00316 2020-07-06
INSTALLATION
Lower Track Assembly
(EXTENDED PROJECTION)
Continued
Left (Non-Drive) Side
E
D
A
B
C
1 Install the front (A) and rear (B) bottom re-feed
roller assemblies on the lower track (C), using (6)
3/8in-16 x 3in [M10 x 76mm] hex head machine
screws (D) and (6) 3/8in-16 [M10] nylock nuts (E)
G
J
H
F
I
2 Assemble the header plate (F) and top re-feed
roller assemblies (G) on the lower track, using
(2) 3/8in-16 x 6in [M10 x 152mm] hex head machine
screws (H), (4) 3/8in-16 x 6 1/2in [M10 x 165mm] hex
head machine screws (I) and (2) of (6) 3/8in-16 [M10]
nylock nuts (J)
NOTE:
DO NOT install the remaining 4 lock nuts on
the longer machine screws (I) until the next step
K
J
3 Place the tensioner mounting block (K) with the
tapped holes facing up towards the header plate
over the longer machine screw threads Fasten with
(4) 3/8in-16 [M10] nylock nuts (J)
O
L
P
N
M
N
4 Install the vertical re-feed bracket (L) and upper
feed assembly (M) on the lower track, using
(4) 3/8in-16 x 4in [M10 x 102mm] hex head machine
screws (N), (4) 3/8in-16 [M10] nylock nuts (O), and
(2) #14 x 1 1/4in [M6 x 32mm] hex washer head self
drill/tap screws (P)
Figure 21
Figure 22
Figure 23
Figure 24