RITE-HITE FasTrax XL, Installation/Service/Owner'S Manual

Page: 31 / 92

Rite‑Hite
®
Installation/Service/Owner's Manual
FasTrax
®
XL
Publication: AMEN00316 2020-07-06 31
INSTALLATION
Non-Drive Side
NOTE:
Standard Projection version shown
A
B
C
D
E
F
H
I
J
K
G
1 Install the counterweight pulley mounting bracket (A)
to the header plate using (4) 1/4in-20 x 1 1/2in
[M6 x 38mm] hex head cap screws and 1/4in [M6]
lock washers (B)
2 Install the stepped bushing (C) and counterweight
idler pulley (D) to the mounting bracket using (1)
1/2in-13 x 3in [M13 x 76mm] hex head machine
screw (E) and 1/2in [M13] lock washer (F)
3 Install the key (G) in the drive tube shaft, and install
the counterweight pulley (H) Align the counterweight
pulley with the idler pulley (D) and tighten the set
screws to secure the counterweight pulley to the
shaft
4 Install the photoeye sensors (I) onto the sensor
bracket (J) Install the sensor bracket on the header
plate using (2) #14 x 3/4in [6mm x 19mm] hex washer
head self drill/tap screws (K)
M
L
K
5 Install the terminal block assembly (L) on the lower
track using (2) #14 x 3/4in [6mm x 19mm] hex head
self drill/tap screws (K)
6 Route fish tape through the rear brace, through the
holes (M) in the header plates
7 Connect the free end of the non-drive side electrical
cable to the fish tape and pull cable to the drive side
O
Q
Q
P
N
8 Install the cover brackets (N-P), using 2 self drill/tap
#14 x 3/4in [6mm x 19mm] zinc screws (Q) for each
bracket
Figure 47
Figure 48
Figure 49