RITE-HITE FasTrax XL, Installation/Service/Owner'S Manual

Page: 33 / 92

Rite‑Hite
®
Installation/Service/Owner's Manual
FasTrax
®
XL
Publication: AMEN00316 2020-07-06 33
INSTALLATION
N.P.O. (Non-Powered Opening)
(OPTIONAL)
X
X
≈ 54in
[1372mm]
O
J
B
A
D
E
G
F
I
H
X
= 12in [305mm]
NPO kit comes in 1 box:
NOTE:
NPO is assembled for a right hand drive door
To switch for a left hand drive door:
a Loosen the 2 side bolts and rotate the hand chain
guide 180°
b The fault switch must be moved to the opposite side of
the engagement arm bracket (D)
c Remove the hand lever/chain blocker assembly (J)
and rotate to opposite side of bracket
1 Install 1/8in [3mm] spacer (A) on the outside of the
lock collar (B)
2 Install encoder sprocket (H) with hub pointing away
from the gearbox
3 Install engagement arm bracket (D) with limit switch
toward gearbox
4 Install the (2) 1/4in x 1/2in [M6 x 13mm] bolts and
1/4in [M6] lock washers through the engagement arm
on the top and side to hold the bracket in place
( Figure 53 on page 34 ) Use the front top hole (T)
and the bottom side hole (U) ( Figure 54 on page
34 )
5 Slide the engagement assembly (E)
(so engagement pins are pointing away from gearbox)
onto the shaft tight to the spacer and the mounting
bracket and place the 3/16in x 1/4in x 2 3/4in
[5mm x 6mm x 70mm] key in the keyway
6 Slide the drive sprocket (F) onto the shaft with the
hub pointing away from the gearbox
7 Place the 1/16in [2mm] thick spacer (G) and the
lock collar (I) on the shaft Be sure to push all of the
components tight to the gearbox before tightening the
lock collar
Figure 52