Riester 04045396208797, Instructions For Use Manual

Page: 47 / 184

RBP- 100
The higher value is the one that determines the evaluation. Example: a readout value between
150/85 or 120/98 mmHg indicates «blood pressure too high».
5.2 IRREGULAR HEARTBEAT
This device is an oscillometric blood pressure monitor that also analyses irregular heartbeats
during measurement. The irregular heartbeat symbol (26) is displayed after the measurement
if irregular heartbeats occur during measurement. This device does not replace a cardiac
examination, but helps to detect heartbeat irregularities at an early stage.
Note:
- When you manually re-inflate the cuff, irregular heartbeats are not detected.
- When you manually deflate the cuff rapidly, irregular heartbeats are not detected.
6. MEMORY
6.1 VIEWING STORED VALUES
Press the “+” (5) or “-“ (6) buttons briefly when in standby mode. “M” (24) indicates that you are
in the memory mode. The display shows «N=» (21) and a value, e.g. «N=17». This means that
there are 17 values in the memory. The reading with the highest memory number is the latest
performed measurement. Pressing the “+” (5) or “-“ (6) buttons repeatedly enables you to move
from one stored value to another.
Note:
- “0 0 0” is displayed when no measurement data in device memory.
- Each stored reading shows the Systole (17) , Diastole (18), pulse rate (19), Mean Arterial
Pressure (MAP) (22), measurement mode, time and date. The pulse rate and the MAP
alternate on the display every two seconds.
- When an irregular heartbeat was detected during a measurement, this symbol (26) is
additionally shown in the stored value.
- Press and hold the “+” (5) or “-“ (6) buttons when you want to rapidly move through the
stored values.