Riester 04045396208797, Instructions For Use Manual

Page: 113 / 184

RBP- 100
Seite 16 von 23
-
To prove if all display segments and the display illumination unit are working correctly, press
and hold the “+” (5) or “-­“ (6) buttons. All display segments appear and the display
illumination should activate.
9.3 Cleaning the cuff
Carefully remove spots on the cuff with a damp cloth and soapsuds.
WARNING: Do not wash the cuff in a washing machine or dishwasher!
9.4 Accuracy test
We recommend this device is tested for accuracy every 2 years or after mechanical impact (e.g. being
dropped). Please contact your local Riester Service to arrange the test (see foreword).
Monitoring of instruments
All countries except for Germany:
The respective legal provisions apply for all countries, except for Germany. The reference manometer,
which is used for calibration, must be traceable to national and international measurement standards.
It is not allowed to make changes to the device!
9.4.1. Verification of Calibration (Static)
Test equipment:
Equipment Required:
9.4.1.1 Calibrated reference manometer (1) or equivalent (pressure reference).
9.4.1.2 500ml volume (3).
9.4.1.3 Hand Inflation Bulb (4) with Bleed valve (pressure control).
9.4.1.4 Blood pressure device (2) to be tested.
To perform Calibration Verification, proceed as follows:
9.4.1.6 Make the necessary connections using the materials listed in the Equipment
Required list. See Figure 1 for pneumatic connections.
9.4.1.7 Enter the calibration verification mode at the RBP-­100: The device must be switched off
Press the Start / Stop button and turn on the power switch at the same time.
Figure1: Pneumatic connections for verifying BP calibration.
9.4.1. COMPROBACIÓN DE LA CALIBRACIÓN (ESTÁTICA)
Equipamiento para la prueba:
Equipamiento requerido:
9.4.1.1
Nanómetro calibrado (1) o equivalente (referencia de presión).
9.4.1.2 Volumen 500ml (3).
9.4.1.3 Pera de insuflación (4) con válvula de descarga (control de presión).
9.4.1.4 Dispositivo de presión arterial (2) para probarlo.
Para realizar la comprobación de la calibración, haga lo siguiente:
9.4.1.6
Realice las conexiones necesarias utilizando los materiales enumerados en la lista de
equipamiento requerido. Consulte la figura 1 para las conexiones neumáticas.
9.4.1.7 Acceda al modo de comprobación de la calibración en el RBP-100: el dispositivo debe
estar apagado. Presione el botón de Start/Stop y pulse el interruptor de encendido al
mismo tiempo.
Figura 1: conexiones neumáticas para verificar la calibración de la presión arterial.