2.2 Precautions and safety instructions
Precautions
GENERAL
A system can be dangerous. Safety precautions and instructions are important.
•
If these precautions cannot be obeyed, then use warnings.
•
The responsibility for precautions and warnings lies with the installer of the system. Refer to the,
local or national, laws and regulations of the country if a certification (mark) is necessary.
•
Parts of the electrical or electronic installations are connected to dangerous electrical voltages.
This is also applicable if the drive unit is not in operation or the motor does not turn. Work
without professional competence or not obeyed warning instructions could cause injury and/or
material damage.
•
Make sure that no foreign particles, loose parts, moisture or dust go into the components (EM,
gearbox, RLS/RSU) during all work. There is a risk of short circuit, fire and corrosion.
•
Take sufficient precautions to prevent ElectroStatic Discharge (ESD).
•
Ridder is not responsible for injury, material damage or consequential damage if accessories are
used that Ridder did not make.
TRANSPORT, STORAGE AND PACKAGING
The conditions and instructions that follow are applicable.
•
Ambient temperature: -15 to +60 °C (+5 to +140 °F).
•
Ambient: A not-condensed relative humidity is necessary.
•
Do a check for transport damage and missing parts immediately on incoming goods.
•
Tell damages and missing parts immediately to the transport company and to your local After
Sales contact person.
•
Do not use damaged products and if necessary do not start the work.
•
Do not remove the product from the (sealed) packaging before it is sent to the installation site.
This prevents damage (from mechanical shocks) to the product.
•
Use applicable means-of-transport with dimensions which are sufficient. Use (if necessary) the
correct work equipment and accessories. Refer to “Dimensions” and “Technical specifications”.
Make sure that the working conditions comply with the, local or national, laws and regulations.
•
Make sure that storage areas and the areas in the means-of-transport are dry and the airflow is
sufficient.
•
Make sure that the products do not touch the (moist) bottom surface of storage areas and of the
means-of-transport (use pallets or such). The bottom surfaces must be smooth.
•
Make sure that the products are protected from dust, dirt and direct sunlight.
•
Apply an applicable corrosion-preventive agent to metal surfaces that are not painted.
•
After installation discard the packaging and obey the applicable national and/or local regulations.
Ridder Drive Systems B.V.
T
+31 (0)341 416 854 -
F
+31 (0)341 416 611 -
I
5
